Diffrent types of trusses and space frames. Wind and static load analysis of trusses. Design of truss sections. Design of steel beams and columns.
| Ch. 1 | Introduction | ||
| 1.1 | Course Syllabus References and Others | View | |
| Ch. 2 | Truss | ||
| 2.1 | Introduction | View | |
| 2.2 | Truss Analysis - Joint Method | View | |
| 2.3 | Truss Analysis - Section Method | View | |
| Ch. 3 | Wind Loads | ||
| 3.1 | Wind Loads Basics | View | |
| 3.2 | Wind Analysis for Roof Truss | View | |
| Ch. 4 | Column Design | ||
| 4.1 | Trial and Error Method | View | |
| 4.2 | Using Column Load Table | View | |
| 4.3 | Biaxial Buckling | View | |
| Ch. 5 | Truss Design | ||
| 5.1 | Tension Member | View | |
| 5.2 | Compression Member | View | |
| Ch. 6 | Beam | ||
| 6.1 | Plastic Moment and Section Modulus | View | |
| 6.2 | Local Buckling | View | |
| 6.3 | Lateral Torsional Buckling | View |
Students must complete CEE 311 Structure III course prior to register for this course.
| Activities | Percentage | Remarks |
|---|---|---|
| Attendance | 5% | Less than 70% cannot sit for final exam |
| Mid Term Exam | 20% | Answer 2 questions out of 3 |
| Final Exam | 50% | Answer 4 questions out of 5 |
| Quiz | 10% | Best 2 out of 3 |
| Assignment | 15% | All of 2 out of 2 |
There are 2 sessions per week, 1 hour on each session.